RustMinerSystem

Documentation

Deploy and Pair RMS with RustMinerSystem

Prepare RustMinerSystem RMS2, RMS3, RMS3(Zstd), or RMS3(NB) ports and pair RMS through a push URL or manual setup.

Deployment and Pairing

Pairing connects a local RMS instance to a compatible RustMinerSystem protocol port and creates a stable LAN address for miners.

Prepare the Server First

  1. Open RustMinerSystem and enter the mining-pool proxy area.
  2. Create an RMS2, RMS3, RMS3(Zstd), or RMS3(NB) port for the target coin.
  3. Set the listener, upstream pool, and target pool protocol.
  4. Record the port password if one is configured.
  5. Record the exact protocol and applicable compression options.
  6. Confirm the port is running and reachable from the mining site.

RMS3(NB) supports BTC and LTC only. The local and server sides must use the exact same protocol; RMS3, RMS3(Zstd), and RMS3(NB) cannot be mixed even though their names are similar.

Pair with a Push URL

If your deployment provides a central configuration URL:

  1. Enter the push URL on the first-run page.
  2. Wait for RMS to retrieve port configuration.
  3. On the dashboard, verify local ports, coins, protocols, and remote targets.
  4. Validate with a small miner group before expanding.

If retrieval fails, check URL expiry, reachability of the configuration service, and whether the server ports already exist.

Skip and Configure Manually

Without a push URL, select Skip, open the dashboard, and choose Manual Add.

Setting Requirement
Local listener Unused on the LAN and allowed through the local firewall.
Coin Same as the server; NB accepts BTC or LTC only.
Remote protocol Exact match for the server listener.
Remote address hostname-or-ip:port.
Password Same as the server, or blank on both sides.
Compression options Match the server where the selected protocol requires it.

Miner Address

After saving the local port, copy the address from the port table:

stratum+tcp://RMS_LAN_IP:LOCAL_PORT

Miners connect to local RMS, not the remote RMS protocol port. Migrate 1–5 miners first and verify local inbound connections, remote outbound connections, RustMinerSystem workers, and upstream rejects.

Reset the Push Address

Reset Push Address invalidates the old push configuration and returns to first-run setup. Record manual ports, bypass addresses, and the current configuration before using it.

Continue with Port Mapping.